Table of Contents
Advertisement
Configuration
MM/DD/YYYY
DD/MM/YYYY
YYYY/MM/DD
To change the time format, highlight the box beside Time Format and then press
The DVR toggles between 12 Hours (AM/PM) and 24 Hours (military time).
To save your changes, highlight OK and then press
screen without saving the changes.
System Check Screen
Use the System Check screen to check the status (fault condition) of the DVR.
Highlight System Check in the System menu (MENU
Check) and then press
1.
2.
3.
Rev 1.00
Figure 3-12
Highlight the box under the On/Off heading and then press
between On and Off.
When it is On, the DVR reports a fault condition if it does not detect any
recording or if there is an alarm during the designated time.
Highlight the box under the Interval heading and then press
displays allowing you to set the check interval from 1 Hour to 30 Days by using
the Left and Right Arrow buttons.
The Status field displays the fault conditions.
Good means that there was recording or an alarm occurred during the
designated time.
Bad indicates that there was no recording or no alarm occurred during the
designated time.
. The System Check setup screen displays.
System Check Screen
32
. Select Cancel to exit the
System
System
. This toggles
. A slide bar
Document 900.0258
.
09/04
Advertisement
Table of Contents
