Table of Contents
Advertisement
Configuration
1.
2.
3.
4.
5.
Time-Lapse Record Mode Setup Screen
Access the Time-Lapse Record Setup screen (MENU
Record) and then press
Rev 1.00
Highlight the box beside Record Resolution and select from High and
Standard. All the other variables being equal, selecting High decreases the
recording and playback speed by half of Standard.
Highlight the box beside End Of Disk and then press
Overwrite and Stop.
In Overwrite mode, the DVR continues recording when the hard disk drive is
full by overwriting the oldest video.
In Stop mode, the DVR stops recording when the hard disk drive is full.
If the DVR is set to Stop mode, you can set it to beep or activate the Alarm Out
AO1 port when the hard disk drive is full. Highlight the box beside On Disk
Full: Beep and press
On Disk Full: Alarm Out and then press
Highlight the box beside Field Detect. Press
When set to On, the Field Detection helps prevent shaking. It does this by
recording odd numbered fields from odd numbered cameras and even numbered
fields from even numbered cameras.
Note
When Field Detect is set to On, single channel recording is
limited to 30 ips.
To save your change, highlight OK and then press
screen without saving the changes.
Figure 3-28
to toggle between On and Off. Highlight the box beside
. The Time-Lapse Record Setup screen displays.
Time-Lapse Record Setup Screen
47
. This toggles between
to toggle between On and Off.
to toggle between On and Off.
. Selecting Cancel exits the
Record
Time-Lapse
Document 900.0258
09/04
Advertisement
Table of Contents
