Installation
Your DVR can record audio.
1.
2.
Connecting Alarms
To make connections on the Alarm Connector Strip:
1.
2.
3.
4.
Rev 1.00
Figure 2-6
Connect the audio source to Audio In.
Connect Audio Out to your amplifier.
Note
The DVR does not have amplified audio output, so you need a
speaker with an amplifier. The audio input can be from an
amplified source or directly from a microphone.
Figure 2-7
Press and hold the button.
Insert the wire in the hole below the button.
After releasing the button, tug gently on the wire to make certain it is connected.
To disconnect a wire, press and hold the button above the wire and pull out the
wire.
Audio In and Out Connectors
AUDIO IN
AUDIO OUT
Alarm Input Connector Strips
9
Document 900.0258
09/04