Table of Contents
Advertisement
Configuration
Caution
4.
5.
6.
LAN Setup Screen
Use the LAN Setup screen (MENU
configure your Local Area Network.
Rev 1.00
Write the password down and keep it in a safe place. After the
password has been reset, the default will no longer work. If the
password is forgotten, the unit must be reset using the Factory
Reset Button and all data settings will be lost.
Highlight the box beside Transfer Control and then press
On and Off. When On, you can set the transfer speed and remote quality of the
image transferred to a computer running RAS (Remote Administration System)
software.
Highlight the box beside Transfer Speed and then press
speed from 1 to 30 ips.
Note
The transfer speed you set is the maximum speed. Depending
on the network environment, this speed may not be achieved.
The transfer speed indicates the image rate transferred to each
RAS. If two remote sites (RAS) are connecting to the DVR, the
number of images transferred via network will be Transfer
Speed x 2.
The Transfer Control option affects the recording performance
of the DVR. The number of remote sites (RAS) connected to
the DVR does not affect the recording speed. The local
recording speed is affected only by Transfer Speed. The local
recording speed is not affected if the DVR is not connected
remotely.
If Transfer Control is not used, data transfer speed to a remote
site will be the same as the local recording speed.
Highlight the box beside Remote Quality and then press
quality from Very High, High, Standard, and Low.
Network
62
to toggle between
. Select the transfer
. Select the image
Network Setup
Document 900.0258
LAN) to
09/04
Advertisement
Table of Contents
