Table of Contents
Advertisement
Operation
display live cameras sequentially (cameo sequence). Selecting another display mode, or
pressing SEQUENCE again exits the Sequence mode. When in one of the multi-view
formats, pressing the Left or Right Arrow buttons causes the DVR to go to the
previous or the next page. For example, if you press the Right arrow button in 2x2
format, the DVR changes the page like the one shown below.
For the sequence display on the spot monitor, press SPOT + SEQUENCE.
Press FREEZE to freeze the current image on the screen until you press the button
again.
Active Cameo Mode
You can enter the Active Cameo mode by pressing
gray-highlight box at the bottom of video indicates the active cameo, and pressing the
Arrow buttons moves the active cameo. Pressing
exits the Active Cameo mode. The active cameo mode will remain in effect for 15
seconds if there is no further action.
In Active Cameo mode, press the camera button of the video you want to show at
active cameo. After setting the camera number at active cameo, the DVR moves the
active cameo to the next cameo. You can change the screen layout using this process.
Active Cameo mode can also be used to select the camera to control Pan, Tilt and
Zoom capabilities.
PIP Mode
You can display a Picture-in-Picture by pressing DISPLAY. You can change the
location of the PIP by pressing the Up and Down Arrow buttons and its size by
pressing the Left and Right Arrow buttons.
Rev 1.00
79
in any multi-view format. The
while in the Active Cameo mode
Document 900.0258
09/04
Advertisement
Table of Contents
