Table of Contents
Advertisement
Configuration
1.
2.
3.
Rev 1.00
Highlight the box under the Speed heading and then press
of record speeds displays. You can select from 1 image per 10 seconds to 60
images per second for NTSC (to 50 images per second for PAL).
Note
If you set the Record Resolution to High, you will not be able to
select 60 ips NTSC (590 ips PAL).
Highlight the box under the Quality heading and then press . A drop-down list
displays. You can select from Very High, High, Standard, and Low image
quality. All other variables being equal, Very High will require 600% more hard
disk space than Standard, High will require 250% more, and Low 30% less.
Note
Higher quality images require more storage space and reduce
the recording capacity of the hard disk drive.
You can set the maximum amount of time-lapse video to be stored. After the
DVR reaches this amount, it will start recording over the oldest time-lapse
video. The time-lapse video is stored separate from Event video. When Keep
the continuous pictures is set to On, you can set the time from 1 Hour to
the maximum allowed by the storage capacity of your hard disk drive.
Note
The maximum storage time is only an estimate because the
amount of space required to store video varies depending on
many factors such as motion and image complexity.
48
. A drop-down list
Document 900.0258
09/04
Advertisement
Table of Contents
