Connecting To The Ultra Wide Scsi Port; Figure 2-13 Scsi Connector - Honeywell HRHD4+ User Manual

Installation

Connecting to the Ultra Wide SCSI Port

A SCSI port is provided to connect external storage devices for recording or archiving
video. Connect the external SCSI hard disk drive (RAID) cable to the high-density
68-pin female UltraWide SCSI port. The length of SCSI cable should not exceed 1.5
meters. You can connect up to four UltraWide SCSI devices with SCSI IDs set to 0,
1, 2, and 3 respectively.
Caution
Caution
Rev 1.00
Figure 2-13 SCSI Connector
Note The SCSI bus must be terminated properly, otherwise the DVR
will not operate properly.
Do NOT connect the SCSI device while the SCSI DVR power is
on. The DVR must be powered down to connect the SCSI device
and powered up again after the SCSI device has been connected.
Power up the SCSI device so it is ready for operation in advance
of powering up the DVR.
If the SCSI device is shut down while the device is operating, the
DVR system may not work normally.
13 Document 900.0258
09/04