Upc-A/Ean-13 With Extended Coupon Code - Honeywell ORBIT 7120PLUS User Manual

Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for
milliseconds) for this timeout by scanning the bar code below, then setting the tim-
eout by scanning digits from the
this manual, then Save. Default = 300.
Note: The Addenda Timeout maximum length is determined by the Reread Delay setting.
See
and coupon code searches.
UPC-A Addenda Separator
When this feature is On, there is a space between the data from the bar code and
the data from the addenda. When turned Off, there is no space. Default = On.

UPC-A/EAN-13 with Extended Coupon Code

Use the following codes to enable or disable UPC-A and EAN-13 with Extended
Coupon Code. When left on the default setting (Off), the scanner treats Coupon
Codes and Extended Coupon Codes as single bar codes.
If you scan the Allow Concatenation code, when the scanner sees the coupon
code and the extended coupon code in a single scan, it transmits both as one sym-
bologies. Otherwise, it transmits the first coupon code it reads.
108
Reread Delay (page 42). The Addenda Timeout setting is applied to all addenda
* On
UPC-A Addenda
Programming Chart,
Addenda Timeout
* Not Required
Required. Set the length (in
beginning on page 225 of
Orbit 7120plus/7190g User Guide
Off