Connect With Rs485; Reading Techniques; Menu Bar Code Security Settings - Honeywell ORBIT 7120PLUS User Manual

Connect with RS485

The scanner can be connected for an IBM POS terminal interface.
1. Connect the appropriate interface cable to the device, then to the computer.
2. Turn the terminal/computer power back on. The scanner beeps.
3. Verify the scanner operation by scanning a bar code from the
For further RS485 settings, refer to RS485, page 8.

Reading Techniques

Present the bar code to the scanner. When using an Orbit 7190g, the LEDs turn up
to read the code. If the light level in the room is not high enough, the code may not
be read.

Menu Bar Code Security Settings

Honeywell scanners are programmed by scanning menu bar codes or by sending
serial commands to the scanner. If you want to restrict the ability to scan menu
codes, you can use the Menu Bar Code Security settings. Contact the nearest tech-
nical support office (see
Orbit 7120plus/7190g User Guide
on page 223. The scanner beeps once.
Technical Assistance
Sample Symbols
on page xi) for further information.
5