Add A Prefix Or Suffix; Add A Tab Suffix To All Symbologies - Honeywell ORBIT 7120PLUS User Manual

•
•
•

Add a Prefix or Suffix

1. Scan the Add Prefix or Add Suffix symbol
2. Determine the 2 digit hex value from the
3. Scan the 2 hex digits from the
Note: When adding a backslash (\), you must scan 5C twice – once to create the leading
backslash and then to create the backslash itself.
5. Repeat Steps 2 and 3 for every prefix or suffix character.
6. Scan
Repeat the steps above to add a prefix or suffix for another symbology.

Add a Tab Suffix to All Symbologies

1. Scan Add Suffix.
2. Scan 9, 9 from the
3. Scan 0, 9 from the
4. Scan Save, or scan Discard to exit without saving.
60
Enter prefixes and suffixes in the order in which you want them to appear on the
output.
When setting up for specific symbologies (as opposed to all symbologies), the
specific symbology ID value counts as an added prefix or suffix character.
The maximum size of a prefix or suffix configuration is 200 characters, which
includes header information.
211 for the symbology to which you want to apply the prefix or suffix. For
example, for Code 128, Code ID is "j" and Hex ID is "6A".
scan 9, 9 for all symbologies.
a. To add the Code I.D., scan 5, C, 8, 0.
b. To add the AIM I.D., scan 5, C, 8, 1.
c. To add the serial number, scan 5, C, 8, 8.
d. To add a backslash (\), scan 5, C, 5, C.
Save to exit and save, or scan Discard to exit without saving.
Programming Chart,
suffix to all symbologies.
Programming Chart,
corresponds with the hex value for a horizontal tab, shown in the
Conversion Chart (Code Page 1252),
(page 62).
Symbology Charts,
Programming Chart,
beginning on page 225 to apply this
beginning on page 225. This
beginning on page 214.
Orbit 7120plus/7190g User Guide
beginning on page
beginning on page 225, or
ASCII