Honeywell ORBIT 7120PLUS User Manual page 90

B0 Example: Send bar code data that starts after a string of characters
Search for the letters "FGH" in bar codes and send all the data that follows, includ-
ing "FGH." Using the bar code above:
Command string: B00003464748F10D
B0 is the "Search forward for a string" command
0003 is the string length (3 characters)
46 is the hex value for "F"
47 is the hex value for "G"
48 is the hex value for "H"
F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as:
FGHIJ
<CR>
Search backward for a string
B1 Search backward for "s" string from the current cursor position, leaving cursor
pointing to "s" string. Syntax = B1nnnnS where nnnn is the string length (up to
9999), and S consists of the ASCII hex value of each character in the match string.
For example, B1000454657374 will search backward for the first occurrence of the
4 character string "Test."
Refer to the
decimal, hex and character codes.
Search forward for a non-matching character
E6 Search the input message forward for the first non-"xx" character from the current
cursor position, leaving the cursor pointing to the non-"xx" character. Syntax = E6xx
where xx stands for the search character's hex value for its ASCII code. Refer to the
ASCII Conversion Chart (Code Page 1252),
and character codes.
E6 Example: Remove zeros at the beginning of bar code data
76
ASCII Conversion Chart (Code Page 1252), beginning on page 214 for
beginning on page 214 for decimal, hex
Orbit 7120plus/7190g User Guide