End Character Activation After Good Read; Character Activation Timeout - Honeywell ORBIT 7120PLUS User Manual

following bar code, then scan the alphanumeric combination that represents that
ASCII character from the
Save. Default = 12 [DC2].

End Character Activation After Good Read

After a bar code is successfully detected and read from the scanner, the illumina-
tion can be programmed either to remain on and scanning, or to turn off. When
End Character Activation After Good Read is enabled, the illumination turns off
and stops scanning after a good read. If you scan Do Not End Character Activa-
tion After Good Read, the illumination remains on after a good read. Default = End
Character Activation After Good Read.
Activation After Good Read

Character Activation Timeout

You can set a timeout for the length of time the illumination remains on and
attempting to decode bar codes when using Character Activation Mode. Set the
length (in milliseconds) for a timeout by scanning the following bar code, then set-
ting the timeout (from 1-300,000 milliseconds) by scanning digits from the
Programming Chart,
ms.
Orbit 7120plus/7190g User Guide
Do Not End Character
beginning on page 225, then scanning Save. Default = 30,000
Programming Chart,
Activation Character
Character Activation Timeout
beginning on page 225, then scan
* End Character Activation
After Good Read
47