Honeywell ORBIT 7120PLUS User Manual page 125

Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for
(in milliseconds) for this timeout by scanning the bar code below, then setting the
timeout (from 0-65535 milliseconds) by scanning digits from the
Chart,
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
UPC-E0 Addenda Separator
When this feature is On, there is a space between the data from the bar code and
the data from the addenda. When turned Off, there is no space. Default = On.
UPC-E0 Check Digit
Check Digit specifies whether the check digit should be transmitted at the end of
the scanned data or not. Default = On.
Orbit 7120plus/7190g User Guide
beginning on page 225 of this manual, then Save. Default = 100.
Addenda Timeout
* On
* On
UPC-E0 Addenda Required. Set the length
Programming
Off
Off
111