Honeywell ORBIT 7120PLUS User Manual page 223

Is the bar code displayed but not entered?
The bar code is displayed on the host device correctly, but you still have to press a
key to enter it (the Enter/Return key or the Tab key, for example).
•
The scanner won't read your bar code at all.
1. Scan the sample bar codes in the back of this manual. If the scanner reads the
2. If the scanner still can't read the sample bar codes, scan
If you aren't sure what programming options have been set in the scanner, or if you
want the factory default settings restored, refer to
page 173.
Orbit 7120plus/7190g User Guide
You need to program a suffix. Programming a suffix enables the scanner to
output the bar code data plus the key you need (such as "CR") to enter the data
into your application. Refer to
information.
sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see
On, page 86.
Prefix/Suffix Overview
Reset the Factory Defaults
on page 59 for further
Chapter 6).
All Symbologies
on
209