Add A Data Format - Honeywell ORBIT 7120PLUS User Manual

If you have changed data format settings, and wish to clear all formats and return
to the factory defaults, scan the Default Data Format code below.

Add a Data Format

Step 1.
Step 2.
Step 3.
Note: 099 indicates all terminal types.
Step 4.
Note: 99 indicates all symbologies.
Step 5.
Note: 9999 indicates all lengths.
Step 6.
66
Scan the Enter Data Format symbol
Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate
formats. This allows you to save a total of 4 different data formats. To
program your primary format, scan 0 from the
beginning on page 225. If you are programming an alternate format,
scan 1, 2, or 3, depending on which alternate format you are
programming. (See
further information.)
Terminal Type
Refer to Terminal ID Table
for your PC. Scan three numeric bar codes from the
beginning on page 225, to program the scanner for your terminal ID (you
must enter 3 digits). For example, scan 0 0 3 for an AT wedge.
Code I.D.
In the Symbology Charts,
which you want to apply the data format. Locate the Hex value for that
symbology and scan the 2 digit hex value from the
beginning on page 225.
If you wish to create a data format for all symbologies, with the exception
of some specific symbologies, refer to B8
If you are creating a data format for Batch Mode Quantity, use 35 for the
Code I.D.
Length
Specify what length (up to 9999 characters) of data will be acceptable for
this symbology. Scan the four digit data length from the
Chart, beginning on page 225. For example, 50 characters is entered as
0050.
Editor Commands
Refer to Data Format Editor Commands
represent the command you want to enter.
* Default Data Format
(page
Primary/Alternate Data Formats
(page 68) and locate the Terminal ID number
beginning on page 211, find the symbology to
Orbit 7120plus/7190g User Guide
67).
Programming Chart,
on page 82 for
Programming Chart,
Programming Chart,
(page 80).
Programming
(page 68). Scan the symbols that