Beep On Bel Character; Centering; Single Code Centering; Custom Centering Settings - Honeywell ORBIT 7120PLUS User Manual

Beep on BEL Character

You may wish to force the scanner to beep upon a command sent from the host. If
you scan the Beep on BEL On bar code below, the scanner will beep every time a
BEL character is received from the host. Default = Beep on BEL Off.

Centering

Use Centering to narrow the scanner's field of view to make sure that when the
scanner is hand-held, it reads only those bar codes intended by the user. For
instance, if multiple codes are placed closely together, centering will insure that
only the desired codes are read. Using the Centering features, the scanner can
emulate the operation of older systems, such as linear laser bar code scanners.)
Note: To adjust centering when the scanner is in Presentation Mode, see
Centering

Single Code Centering

Scan Single Code Centering to target the bar code closest to the center of the
image. Singling out a bar code in this manner increases scanning accuracy when
there are multiple bar codes close together.

Custom Centering Settings

Use the following settings to customize your centering window. If a bar code is not
touched by a predefined window, it will not be decoded or output by the scanner. If
centering is turned on by scanning Centering On, the scanner only reads codes
that pass through the centering window you specify using the Top of Centering
Window, Bottom of Centering Window, Left, and Right of Centering Window bar
codes.
Orbit 7120plus/7190g User Guide
*Beep on BEL Off
(page 39).
Single Code Centering
Beep on BEL On
Presentation
49