Character Activation Mode; Activation Character - Honeywell ORBIT 7120PLUS User Manual

Command
[ESC] b,
[ESC] 1,
[ESC] 2,
[ESC] 3,
[ESC] 4,
[ESC] 5,
[ESC] 6,
[ESC] 7,
[ESC] 8,[ESC] 8,

Character Activation Mode

Y2ou may use a character sent from the host to trigger the scanner to begin scan-
ning. When the activation character is received, the scanner continues scanning
until either the
is received (see
Scan the following On bar code to use character activation, then use Activation
Character (following) to select the character you will send from the host to start
scanning. Default = Off.

Activation Character

This sets the character used to trigger scanning when using Character Activation
Mode. On the
value that represents the character you want to use to trigger scanning. Scan the
46
Action
Razz or error tone to indicate a menu change was unsuccessful.
The white LED illuminates for 135 milliseconds followed by a pause.
The white LED illuminates for 2 seconds followed by a pause.
The white LED illuminates for 5 seconds followed by a pause.
Emits a beep at a low pitch.
Emits a beep at a medium pitch.
Emits a beep at a high pitch.
Beeps to indicate a successful decode and communication to host.
Razz or error tone to indicate a decode/communication to host was
unsuccessful.
Character Activation Timeout
Deactivation Character
* Off
ASCII Conversion Chart (Code Page
(page 47), the deactivation character
on page 48), or a bar code is transmitted.
1252), page 214, find the hex
Orbit 7120plus/7190g User Guide
On