Search Commands - Honeywell ORBIT 7120PLUS User Manual

Search Commands

Search forward for a character
F8 Search the input message forward for "xx" character from the current cursor
position, leaving the cursor pointing to the "xx" character. Syntax = F8xx where xx
stands for the search character's hex value for its ASCII code.
Refer to the
decimal, hex and character codes.
F8 Example: Send bar code data that starts after a particular character
Search for the letter "D" in bar codes and send all the data that follows, including
the "D." Using the bar code above:
Command string: F844F10D
F8 is the "Search forward for a character" command
44 is the hex value for "D"
F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as:
DEFGHIJ
<CR>
Search backward for a character
F9 Search the input message backward for "xx" character from the current cursor
position, leaving the cursor pointing to the "xx" character. Syntax = F9xx where xx
stands for the search character's hex value for its ASCII code.
Refer to the
decimal, hex and character codes.
Search forward for a string
B0 Search forward for "s" string from the current cursor position, leaving cursor
pointing to "s" string. Syntax = B0nnnnS where nnnn is the string length (up to
9999), and S consists of the ASCII hex value of each character in the match string.
For example, B0000454657374 will search forward for the first occurrence of the 4
character string "Test."
Refer to the
decimal, hex and character codes.
Orbit 7120plus/7190g User Guide
ASCII Conversion Chart (Code Page 1252),
ASCII Conversion Chart (Code Page 1252),
ASCII Conversion Chart (Code Page 1252),
beginning on page 214 for
beginning on page 214 for
beginning on page 214 for
75