Chapter 7 - Imaging Commands; Single-Use Basis; Command Syntax - Honeywell ORBIT 7120PLUS User Manual

CHAPTER
7
IMAGING COMMANDS
The Orbit 7120plus/7190g scanner has a laser system and an imaging system.
The imaging system is like a digital camera in the way it captures, manipulates, and
transfers images. The following commands allow you to alter the way the scanner
performs these functions.

Single-Use Basis

Imaging Commands with their modifiers send instructions to the scanner on a sin-
gle-use basis, and take effect for a single image capture. Once that capture is com-
plete, the scanner reverts to its imaging default settings. If you want to
permanently change a setting, you must use the serial default commands (see
Chapter
new, permanent setting for the scanner.

Command Syntax

Multiple modifiers and commands can be issued within one sequence. If additional
modifiers are to be applied to the same command, just add the modifiers to that
command. For example, to add 2 modifiers to the Image Snap command, such as
setting the Imaging Style to 1P and the Wait for Trigger to 1T, you would enter
IMGSNP1P1T.
Note: After processing an image capture command (IMGSNP), you must follow it with an
IMGSHP command if you want to see it on your terminal.
To add a command to a sequence, each new command is separated with a semico-
lon. For example, to add the Image Ship command to the above sequence, you
would enter IMGSNP1P1T;IMGSHP.
The imaging commands are:
Image Snap - IMGSNP
Image Ship - IMGSHP
Orbit 7120plus/7190g User Guide
9). When the serial default command is used, that selection becomes the
(page 150)
(page 153)
149