Coupon Gs1 Databar Output - Honeywell ORBIT 7120PLUS User Manual

If you scan the Require Concatenation code, the scanner must see and read the
coupon code and extended coupon code in a single read to transmit the data. No
data is output unless both codes are read. Default = Off.
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for
Code. Set the length (in milliseconds) for this timeout by scanning the bar code
below, then setting the timeout (from 0-65535 milliseconds) by scanning digits
from the
Default = 100.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.

Coupon GS1 DataBar Output

If you scan coupons that have both UPC and GS1 DataBar codes, you may wish to
scan and output only the data from the GS1 DataBar code. Scan the GS1 Output
On code below to scan and output only the GS1 DataBar code data. Default = GS1
Output Off.
Orbit 7120plus/7190g User Guide
* Off
Require Concatenation
Programming Chart,
* GS1 Output Off
UPC-A/EAN-13 with Extended Coupon
beginning on page 225 of this manual, then Save.
Addenda Timeout
Allow Concatenation
GS1 Output On
109