Parking Brake Switch Test
1. Disconnect the parking brake switch connector (A)
from the switch (B).
2. Check for continuity between the positive terminal
(C) and body ground.
• With the parking brake pedal pressed, there
should be continuity.
• With the parking brake pedal released, there
should be no continuity.
NOTE:
• If both the ABS or TCS indicator and the brake
system indicator come on at the same time,
check the ABS (see page 19-41) or TCS (see page
19-81) first.
• If the parking brake switch/fluid level switch is
OK, but the brake system indicator does not
function, check the ABS or TCS (For Canada
model: do the input test for the daytime running
lights control unit first.
A
C
B
Brake Fluid Level Switch Test
1. Remove the reservoir cap (A). Check that the float
(B) moves up and down freely; if it does not,
replace the reservoir cap assembly.
D
C
B
2. Check for continuity between the terminals with the
float in the down position (C) and the up position
(D):
• With the float up, there should be no continuity.
• With the float down, there should be continuity.
A
19-11
19-11