Parking Brake Switch Test; Brake Fluid Level Switch Test - Honda Accord 2008 Manual

07/11/02 09:31:45 61TA0000_190_0011

Parking Brake Switch Test

NOTE: If both the ABS/VSA indicator and the brake
system indicator come on at the same time, check the
VSA system first (see page 19-46).
1. Remove the center console (see page 20-147).
2. Disconnect the parking brake switch connector (A)
from the parking brake switch (B).
＊０１
3. Check for continuity between the switch terminal
(C) and body ground.
• With the parking brake lever pulled, there should
be continuity.
• With the parking brake lever released, there
should be no continuity.
NOTE: If the parking brake switch and the brake
fluid level switch are OK, but the brake system
indicator does not function, do the gauge control
module self-diagnostic function (see page 22-312).
4. Reconnect the parking brake switch connector.
5. Install the center console (see page 20-147).
ＴＡ０８Ａ００Ｄ０００６０８４５１３１ＦＥＡＴ００
A
B
C

Brake Fluid Level Switch Test

1. Disconnect the brake fluid level switch connector.
2. Check for continuity between the terminals (1) and
(2) with the float in the down position and in the up
position.
NOTE:
• Remove the brake fluid completely from the
reservoir. With the float down, there should be
continuity.
• Fill the reservoir with brake fluid to the MAX
(upper) level (A). With the float up, there should
be no continuity.
• If both the ABS/VSA indicator and the brake
system indicator come on at the same time,
check the VSA system first (see page 19-46).
• If the parking brake switch and brake fluid level
switch are OK, but the brake system indicator
does not function, do the gauge control module
test (see page 22-312).
2 1
3. Reconnect the brake fluid level switch connector.
ＴＡ０８Ａ００Ｄ１４３０００１４７４１ＦＥＡＴ００
＊０１
A
19-11 19-11