Wiper Motor Test; Wiper Motor Replacement - Honda 2002 Accord Manual

Wiper/Washer
Wiper M o t o r Test Wiper Motor Replacement
1. Open the hood, and remove the cap nuts and the
wiper arms.
NOTE: Carefully remove the wiper arms, so that
they do not touch the hood.
2. Remove the windshield wiper arms (see page 22-
188).
3. Disconnect the connector from the wiper motor.
4. Test the motor by connecting battery power and
ground according to the table.
If the motor does not run or fails to run smoothly,
replace it.
\ T e r m i n a l
P o s i t i o n \
1 2
4
L O W S P E E D
0 ©
H I G H S P E E D
e
©
5. Connect an analog voltmeter between the No. 5 ( + )
and No. 3 ( —) terminals, and run the motor at low
or high speed. The voltmeter should indicate 0 V
and 4 V or less alternately.
1. Remove the nuts (A) and remove the windshield
wiper arms (B).
B
18 N m (1.8 kgf m , 1 3 I b f f t )
R e m o v e a n d r e p l a c e t h e c l i p s .
2. Remove the hood seal and cowl cover.
3. Remove the bolt (A) and windshield wiper linkage
assembly (B).
9 . 8 N m (1.0 k g f m , 7.2 I b f f t )
D
C
4. Disconnect the connector (C) from the wiper motor
(D).
22-188