Ignition Key Switch Test; Ignition Key Light Test - Honda 2002 Accord Manual

Entry Light Control System
Ignition Key Switch Test
Ignition Key Light Test
NOTE: For m o r e key-in beeper information, refer t o the
circuit d i a g r a m (see page 22-73) and input test (see
page 22-80).
W h e n the ignition key is not removed, the key-in beeper
in the driver's multiplex control unit senses g r o u n d
t h r o u g h the closed ignition key switch. W h e n y o u open
the driver's door, the beeper circuit senses g r o u n d
t h r o u g h the closed door switch.
1. Remove the steering c o l u m n upper and lower
covers (see page 17-25).
2. Disconnect the 7P connector.
1
2 3 4 5 6 7
3. Check for continuity between terminals No. 1 and
No. 3.
• There should be continuity w i t h the key in the
ignition switch.
• There should be no continuity w i t h the key
removed.
4. if continuity is not as specified, replace the ignition
key switch.
1. Remove the steering c o l u m n upper and lower
covers (see page 17-25).
2. Disconnect the 7P connector.
3. The LED should come on w h e n power is connected
to terminal No. 7, and g r o u n d is connected to
terminal No. 6.
4. If the LED does not come on, replace the ignition
key switch.
22-120