Under-Dash Fuse/Relay Box Removal And Installation - Honda 2002 Accord Manual

Under-dash Fuse/Relay Box
Removal and Installation
S R S components are located i n this area. Review the
S R S component locations, precautions, and procedures
in the S R S section before performing repairs or service
(see page 23-28).
Removal
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the radio's
preset buttons.
2. Disconnect the battery negative cable, then
disconnect the positive cable, and wait at least
three minutes.
3. Remove the driver's dashboard lower cover (see
page 20-84) or the passenger's dashboard lower
cover (see page 20-85).
4. Remove the door sill molding, left or right kick
panel (see page 20-74) and fuse box cover (see
page 20-84).
5. Remove the mounting bolt, and pull the driver's
under-dash fuse/relay box (A) or passenger's
under-dash fuse/relay box (B) away from the body.
A
6. Disconnect the driver's or passenger's under-dash
fuse/relay box connectors, and remove the driver's
or passenger's under-dash fuse/relay box.
NOTE: The S R S main harness connector is a
springloaded lock type (see page 23-28).
Installation
1. Connect the connectors to the driver's or
passenger's under-dash fuse/relay box, then install
the driver's or passenger's under-dash fuse/relay
box in the reverse order of removal.
2. Install the left or right kick panel and access panel,
and the door sill molding.
3. Install the dashboard lower cover.
4. Connect both the negative cable and positive cable
to the battery, enter the anti-theft code for the radio,
then enter the customer's radio station presets.
5. Confirm that all systems work properly.
22-50