Wheel Bearing End Play Lnspection; Wheel Runout Inspection - Honda S2000 Service Manual

Wheel Bearing End Play lnspection
1 . Raise the vehicle, and suppon it with safety stands
in the proper locations (see page 1-13).
Remove the wheels, then reinstall the wheel nuts.
Attach the dial gauge. Place the dial gauge against
t h e h u b f l a n g e .
Front:
2.
?
Rear:
M e a s u r e t h e b e a r i n g e n d p l a y m o v i n g t h e b r a k e
disc inward or outwa rd.
Standard:
Front/rear:0 0.05 mm (0 0.002 in.l
l f t h e b e a r i n g e n d p l a y m e a s u r e m e n t i s m o r e t h a n
the standard, replace the wheel bearing.
Wheel Runout Inspection
' 1 .
4 .
Raise the vehicle, and support it with safety stands
in the proper locations (see page 1-13).
Check for a bent or deformed wheel.
Set up the dial gauge as shown, and measure the
a x i a l r u n o u t b y t u r n i n g t h e w h e e l .
Front and rear wheel axial runout:
Standard:
0 0.7 mm {0-0.03 in.)
Service limit: 2.0 mm 10.08 in.)
Readjust the dial gauge to the position shown. and
measure the radial runout.
Fronl and rear wheel radial runout:
Standard:
0-0.7 mm {0 0.03 in.)
Service limit: 1.5 mm (0.06 in.)
lf the wheel runout is out of specification, check the
wheel bearing end play.
lf the bearing end play is within the specification
but the wheel runout is more lhan the service limit,
r e p l a c e t h e w h e e l .
18-9