Wheel Bearing End Play Inspection; Turning Angle Inspection - Honda EP3 Service Manual

Front and Rear Suspension
Wheel Alignment (cont'dl
Turning Angle Inspection
Use commercially-available computerized four wheel
a l i g n m e n t e q u i p m e n t t o m e a s u r e w h e e l a l i g n m e n t
(caster. camber, toe, and turning angle). Followthe
equiDment manufacturer's instructions.
1 . T u r n t h e s t e e r i n g w h e e l f u l l y t o t h e r i g h t a n d l e f t
while applying the brake, and check the turning
angles of both front wheels, lf the turning angle is
not within the specification or the inward turning
angles differ between the right and left side, go to
steD 2.
Turning angle:
lnward: 34'00'+ 2'
Outward: 28'00' {reference)
Check the toe. lf it is correct, but the turning angle
is not within the specification, check ior bent or
damaged suspension components,
18-8
Wheel Bearing End Play Inspec'tion
1. Raise lhe vehicle, and support it with safety stands
in the proper location (see page 1-8). Remove the
w h e e l s .
2. Install suita ble f lat washe rs (A) and wheel nuts, and
tighten the nuts to the specified torque to hold the
b r a k e d i s c s e c u r e l y a g a i n s t t h e h u b .
Front:
108 N.m
(11.0 kgf.m,
80 rbf.ft)
Rear:
108 N.m
3 . S e t u p t h e d i a l g a u g e a g a i n s t t h e h u b f l a n g e a s
shown, and measure the bearing end play moving
the brake disc inward and outward.
Bearing end play:
Standard:
Front/rear: 0 0.05 mm {0 0.002 in.}
4. lf the bearing end play is more than the standard,
replace the wheel bearing.
\
(11.0 kgf.m,80 lbf.ft)