Steering
Steering Wheel Installation
1 . B e f o r e i n s t a l l i n g t h e s t e e r i n g w h e e l , m a k e s u r e t h e
front wheels are aligned straight ahead, then center
the cable reel (A). Do this by first rotating the cable
reel clockwise until it stops. Then rotate it
counterclockwise about two and a half turns. The
a r r o w m a r k ( B ) o n t h e c a b l e r e e l l a b e l s h o u l d p o i n t
straight up.
Position the two tabs (A) of the turn signal
c a n c e l i n g s l e e v e ( B ) a s s h o w n . I n s t a l l t h e s t e e r i n g
wheel onto the steering column shaft, making sure
the steerlng wheel hub (C) engages the pins (D) of
the cable reel and tabs of the canceling sleeve. Do
not tap on the steering wheel or steering column
shaft when installing the steering wheel.
17-8
3. Install the steering wheel nut (A), and tighten it to
the specified torgue.
A
_
B
39 N.m (4.0 kgf m.29lbt ftl
Connect the cruise control set/resume switch
connector (B). fvlake sure the wire harness is routed
and fastened properly.
I n s t a l l t h e d r i v e r ' s a i r b a g , a n d c o n f i r m t h a t t h e
system is operating properly {see page 23-113).
C h e c k t h e h o r n , t u r n s i g n a l c a n c e l i n g a n d c r u i s e
control switches for proper operation.
Reconnect the battery and do the following:
. D o t h e e n g i n e c o n t r o l m o d u l e ( E C M ) i d l e l e a r n
p r o c e d u r e ( s e e p a g e 1 l - 1 3 9 ) ,
. Power window control unit resetting procedure
\see page 22-1281.
. Enter the anti-theft cord for the radio, then enter
the custmer's radio station presets.
. Set the clock.
{
7 .
l r , ' , , t
;. _,:!
'' '1i::..'.' l