2 Parameters
2.2 List of parameters
Note:
For setting p0922/p2079, the value is preset to the end of the PZD telegram.
For p0922 equal to 999 and p2079 not equal to 999, the preset value can be increased.
The value must be set again after changing p0922/p2079.
p2072
Response receive value after PZD failure / Resp aft PZD fail
VECTOR_G
Can be changed: T
Data type: Unsigned32
P-Group: Communications
Not for motor type: -
Min
-
Description:
Sets the response for the receive value (r2090) after PZD failure.
Bit field:
Bit
00
r2074[0...9]
IF1 PROFIdrive diagnostics bus address PZD receive / IF1diag addr recv
B_INF
Can be changed: -
Data type: Unsigned16
P-Group: Communications
Not for motor type: -
Min
-
Description:
Displays the PROFIBUS address of the sender from which the process data (PZD) is received.
Index:
[0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
Note:
IF1: Interface 1
Value range:
0 - 125: Bus address of the sender
65535: Not assigned
r2074[0...19]
IF1 PROFIdrive diagnostics bus address PZD receive / IF1diag addr recv
CU_G130_DP,
Can be changed: -
CU_G130_PN,
Data type: Unsigned16
CU_G150_DP,
P-Group: Communications
CU_G150_PN
Not for motor type: -
Min
-
Description:
Displays the PROFIBUS address of the sender from which the process data (PZD) is received.
Index:
[0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
484
Signal name
Unconditionally open holding brake (p0855) Freeze value
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
1 signal
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
List Manual (LH2), 04/2014, A5E03263479A
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0000 bin
0 signal
Zero the value
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
SINAMICS G130/G150
FP
-