Si Motion Sca (Sn) Cam Track Assignment (Control Unit) - Siemens SINAMICS G150 Manual

[24] = Cam position SCA25 (SN25)
[25] = Cam position SCA26 (SN26)
[26] = Cam position SCA27 (SN27)
[27] = Cam position SCA28 (SN28)
[28] = Cam position SCA29 (SN29)
[29] = Cam position SCA30 (SN30)
Dependency: Refer to: p9501, p9503, p9536
Note: A change only becomes effective after a POWER ON.
SCA: Safe Cam / SN: Safe software cam
p9538[0...29] SI Motion SCA (SN) cam track assignment (Control Unit) / SI Mtn SCA assign.
VECTOR_G Can be changed: U, T
Data type: Unsigned32
P-Group: Safety Integrated
Not for motor type: -
Min
100
Description: Assigns the individual cams to the maximum of 4 cam tracks and defines the numerical value for the SGA "cam
range".
p9538[0...29] = CBA dec
C = Assignment of the cam to the cam track.
Valid values are 1, 2, 3, 4.
BA = Numerical value for the SGA "cam range".
If the position lies in the range of this cam, the value BA is signaled to the safety-relevant logic via the SGA "cam
range" of the cam track set using C.
Valid values are 0 ... 14. Each numerical value may only be used once for each cam track.
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
414
2 Parameters
2.2 List of parameters
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
[0] 100
[1] 101
[2] 102
[3] 103
[4] 104
[5] 105
[6] 106
[7] 107
[8] 108
[9] 109
[10] 110
[11] 111
[12] 112
[13] 113
[14] 114
[15] 200
[16] 201
[17] 202
[18] 203
[19] 204
[20] 205
[21] 206
[22] 207
[23] 208
[24] 209
[25] 210
[26] 211
[27] 212
[28] 213
[29] 214
885