Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 865

27B-48
REAR AXLE -
MB990685
MB990813
Contact plate
Differential Carrier <Vehicles with mechanical LSD>
7. Measure the drive pinion turning torque (with oil seal)
MB990326
8. If the turning torque is not within the standard value,
"FA DRIVE GEAR INSTALLATION
1. Clean the drive gear attaching bolts.
2. Remove the adhesive adhered to the threaded holes
3. Apply the specified adhesive to the threaded holes of
4. Install the drive gear onto the LSD case with the mating
"GA SIDE BEARING INNER RACE INSTALLATION
Contact
plate
Use special tool to press-fit the side bearing inner races into
the differential case.
MB990728
to verify that the drive pinion turning torque complies
with the standard value.
Standard value:
Bearing Companion flange lubrication
division
New None (With anti-rust agent)
Gear oil applied
check the tightening torque of the companion flange
self-locking nut, and the installation of the oil seal.
of the drive gear by turning the special tool (tap M8 x
1.0), and then clean the threaded holes by applying
compressed air.
the drive gear.
Specified adhesive:
3M Stud Locking 4170 or equivalent
marks properly aligned. Tighten the bolts to the specified
torque in a diagonal sequence.
Tightening torque: 84 ± 4 N
Turning torque
0.98 - 1.27 N m
·
0.49 - 0.58 N m
·
m
·