Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 624

Operation inspection
Low speed
High speed
Stop position inspection
(A) Low speed (B) Automatical stop
EXTERIOR -
Windshield Wiper and Washer
INSPECTIONS
WINDSHIELD WIPER MOTOR CHECK
Inspection of windshield wiper motor is conducted by removing
the harness connector with the motor attached to the vehicle.
D
D
FRONT WASHER MOTOR CHECK
(1) The inspection of front washer motor is conducted with
(2) Check that the water is supplied with strong pressure
Operation inspection of windshield wiper motor
rotation in a low or high speed
Connect the battery to the windshield wiper motor to
inspect the operation of motor rotation in a low or high
speed.
Inspection of windshield wiper motor stop position
(1) Connect the battery to the windshield wiper motor
to rotate the motor in a low speed as shown in the
illustration (A) and disconnect the battery during
rotation to stop the motor.
(2) Connect between the terminals and the battery as
shown in the illustration (B) and confirm whether the
motor stops at the automatic stop position after
rotating in a low speed.
the washer hose connected after removing the washer
tank assembly and pouring water in the washer tank.
after energizing terminal number 2 with battery voltage
and earthing terminal number 1.
51-17