Cylinder Head Gasket - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

11A-28

CYLINDER HEAD GASKET

REMOVAL AND INSTALLATION
Caution
If the vehicle is equipped with the Brembo disc brake, during maintenance, take care not to contact
the parts or tools to the caliper because the paint of caliper will be scratched.
Pre-removal and Post-installation Operation
Fuel Outflow Preventive Operation (Refer to GROUP 13A - On-vehicle Service.) <Before removal only>
D
Fuel Leak Check <After installation only>
D
Strut Tower Bar Removal and Installation (Refer to GROUP 42.)
D
Under Cover Removal and Installation (Refer to GROUP 51 - Front Bumper.)
D
Drive Belt Tension Check (Refer to P.11A-7.) <After installation only>
D
Accelerator Cable Adjustment (Refer to GROUP 17 - On-vehicle Service.) <After installation only>
D
Drainage and Refilling Engine Oil (Refer to GROUP 12 - On-vehicle Service.)
D
Drainage and Refilling of Engine Coolant (Refer to GROUP 14 - On-vehicle Service.)
D
Air Cleaner Assembly Removal and Installation (Refer to GROUP 15.)
D
Air Hose E, Air Pipe C, Air hose D Removal and Installation (Refer to GROUP 15 - Intercooler.)
D
Battery Removal and Installation
D
Center Cover Removal and Installation (Refer to P.11A-17.)
D
Accelerator Cable Removal and Installation (Refer to GROUP 17.)
D
Radiator Removal and Installation (Refer to GROUP 14.)
D
Secondary Air Control Valve Bracket Removal and Installation (Refer to GROUP 15 - Secondary Air Supply System.)
D
Crossmember Bar Removal and Installation (Refer to GROUP32 - Engine Roll Stopper, Centermember.)
D
Front Exhaust Pipe Removal and Installation (Refer to GROUP 15.)
D
Starter Removal and Installation (Refer to GROUP 16.)
D
Timing Belt Removal and Installation (Refer to P.11A-34.)
D
ENGINE -
Cylinder Head Gasket