Stabilizer Bar - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

33A-12
FRONT SUSPENSION -
Lower arm
assembly
MB991816

STABILIZER BAR

REMOVAL AND INSTALLATION
Caution
1. Before removing the steering wheel and air bag module assembly, refer to GROUP 52B - Service
Precautions and Air Bag Module and Clock Spring. Also, put the front wheels in straight-ahead
position. Failure to do so may damage the SRS clock spring and render the SRS air bag
inoperative, which results serious driver injury.
2. If the vehicle is equipped with the Brembo disc brake, during maintenance, take care not to
contact the parts or tools to the caliper because the paint of caliper will be scratched. And
if there is brake fluid on the caliper, wipe out quickly.
3. To prevent bushings from breakage, the parts indicated by * should be temporarily tightened,
and then fully tightened with the vehicle on the ground in the unladen condition.
3. Use the special tools to press in the bushing until its
MB990651
MB991576
Outer tube
Lower Arm Assembly/Stabilizer Bar
outer tube is flush with the lower arm assembly surface.