Fuel Tank - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

<Fuel pump and gauge assembly>
High-pressurefuel tube
Harness
connector
Suction hose
<Pipe and gauge assembly>
Harness connector

FUEL TANK

REMOVAL AND INSTALLATION
Pre-removal Operation
Draining Fuel
D
Fuel Pump Connector Disconnection
D
(How To Reduce Fuel Pressure)
(Refer to GROUP 13A - On-vehicle Service.)
Center Exhaust Pipe Removal
D
(Refer to GROUP 15.)
FUEL SUPPLY - On-vehicle Service/Fuel tank
FUEL PUMP AND GAUGE ASSEMBLY, PIPE
AND GAUGE ASSEMBLY (FUEL GAUGE UNIT)
1. Remove the rear seat cushion assembly.
2. Remove the service hole cover.
3. Disconnect the harness connector, high-pressure fuel
4. Unscrew the mounting nuts to remove the fuel pump
Return hose
5. Fuel gauge unit check. (Refer to GROUP 54 -
Suction hose
6. Install the fuel pump and gauge assembly or pipe and
7. Connect the harness connector, high-pressure fuel tube,
8. Install the rear seat cushion assembly.
(Refer to GROUP 52A.)
tube, suction hose, and return hose.
and gauge assembly or pipe and gauge assembly.
Combination Meter.)
NOTE
If the inspection shows that the basic resistance and
the height of float are out of the standard value, replace
the gauge unit.
(Refer to P.13B-8.)
gauge assembly. Tighten the mounting nuts to the
specified torque.
Specified torque: 2.5 ± 0.5 N·m
suction hose, and return hose.
Caution
(1) Snap the high-pressure fuel hose or suction hose
one-touch joint into place, then pull back slightly
on the hose to assure it is securely fitted. However,
the connection should have a play of approx. 3
mm.
(2) Insert the return hose for 20 - 30 mm for
connection.
(Refer to GROUP 52A.)
Post-installation Operation
Center Exhaust Pipe Removal
D
(Refer to GROUP 15.)
Refilling Fuel
D
Checking for Fuel Leaks
D
13B-3