Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 647

42-14
Glass stopper, Spacer, windshield spacer and window dam installation position
Glass stopper
17.5 mm
Windshield
A
A
BODY -
Window Glass
INSTALLATION SERVICE POINTS
"AAWINDSHIELD SPACER/SPACER/GLASS
1. When replacing the windshield, first align it with the body,
and then matchmark them.
2. Use isopropyl alcohol to clean the inside edge of the
windshield and the body flange.
3. Use a primer dampened to apply to the specified area
around the windshield and the body evenly.
4. After applying the primer, let it dry for at least 3 minutes.
Caution
(1) The primer strengthens the adhesive effect, so
(2) Never touch the primer-applied surface.
5. Ensuring that there are no bends or warpages inside
the windshield, position the glass stopper and spacer
and windshield spacer on the specified position.
Glass end line
Align the glass stopper end
with the ceramic notch.
Ceramic line
Align the spacer end
with the glass end line.
B
B
STOPPER/WINDOW DAM/WINDSHIELD
MOLDING/WINDSHIELD INSTALLATION
that be sure to apply it. However, an excessively
thick application will weaken the adhesive effect.
Mark
Seal line
Ceramic line
Window dam
Section A - A
Seal line center
Section B - B
10 mm
Align the window
dam end with
the seal line
mark.
13 mm
Glass end
line
14 mm
Windshield
spacer
Windshield
Spacer