Proportioning Valve, Master - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

35A-18
BASIC BRAKE SYSTEM -
Master cylinder removal steps
1. Clutch hose connection
2. Brake fluid level sensor connector
3. Reservoir cap assembly
4. Brake fluid level sensor
5. Brake pipe connection
6. Proportioning valve
<Vehicles without ABS>
7. O ring <Vehicles without ABS>
8. Master cylinder
Proportioning valve removal steps
<Vehicles without ABS>
5. Brake pipe connection
6. Proportioning valve
7. O ring
Brake booster removal steps
1. Clutch hose connection
2. Brake fluid level sensor connector
A
Measuring distance A
Block gauge
Proportioning Valve, Master Cylinder
and Brake Booster
"BA D Push rod protrusion amount check and
"AA 9. Vacuum hose
"AA 9. Vacuum hose
INSTALLATION SERVICE POINTS
"AA VACUUM HOSE CONNECTION
Insert the vacuum hose to the brake booster with its paint
mark facing upward, and then secure the hose by using the
hose clip.
"BA PUSH ROD PROTRUSION AMOUNT CHECK AND
ADJUSTMENT
1. Measure dimension (A).
Standard value (A) : 8.98 - 9.23 mm
NOTE
When a negative pressure of 66.7 kPa is applied to the
brake booster, the push rod should protrude 10.27 – 10.53
mm.
5. Brake pipe connection
8. Master cylinder
adjustment
(With built-in check valve)
10. Snap pin
11. Pin assembly
12. Clevis
D Remove A/C liquid pipe B
(Refer to GROUP 55A
retaining clip.
- Refrigerant Line.)
13. Brake booster
14. Sealer
Fitting removal steps
(With built-in check valve)
15. Fitting
from the