Door Window Glass Adjustment - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

Bolt
MB990243
Striker
Striker
Rear
Front
Adjusting
hole
BODY -
3. If the door does not open and close smoothly
MB990939
Striker
MB990211
Shim

DOOR WINDOW GLASS ADJUSTMENT

Check that the door glass operates smoothly and moves
along the door glass runchannel when the door window glass
is fully raised and fully lowered. If there is a problem, adjust
by the following procedure.
1. Remove the door trim, and waterproof film. (P.42-27)
2. With the door window glass fully closed, loosen the screw
Adjusting
hole
3. Fully close the door window glass again, and tighten
Doors
(1) Adjustment with the striker (inside the vehicle and
up and down directions)
Change the striker fixing bolt to a temporary bolt,
and using the special tool (MB990939) and hammer,
gently hit the top of the temporary bolt in the direction
to be adjusted.
(2) Adjustment with the striker (outside the vehicle)
Using the special tool (MB990211, MB990243), pull
the striker towards the outside of the vehicle and
adjust.
(3) Adjustment with the shim (to and fro direction)
Adjust the alignment of the door striker and door
latch using the shim of the striker attached portion.
fixing the door glass from the adjustment hole, and lower
the door window glass slightly.
the screw fixing the door glass from the adjustment hole.
42-21