Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 600

Deployment
harness
SRS air bag
adapter harness
MR203491 or
MB628919
Insulation tape
Driver's air bag module
Deployment
harnesses
Tyres without wheels
Deployment harnesses
Air Bag Module and Seat Belt Pre-tensioner
SRS -
Disposal Procedures
Short-circuited
6 m or longer
(2) Connect deployment harnesses longer than 6 m to
each SRS air bag adapter harness and insulate the
connections with plastic tape.
Also, connect the deployment harness in the other
ends to connect (short-circuit). This prevents the
driver's air bag module from accidental deployment
caused by static and etc.
(3) Touch the vehicle's body with bare hands to discharge
static in you.
Caution
Never fail to do Step (3) in order to prevent
accidental deployment caused by static.
(4) Install a nut to the bolt behind the driver's air bag
module and tie thick wire there for securing.
(5) Route the deployment harnesses connected to the
driver's air bag module beneath an old tyre and wheel
assembly. Then, using the wire tied to the bolt, secure
the driver's air bag module to the tyre and wheel
assembly with the deployment surface facing up.
(6) Place three old tyres without wheels on the tyre
secured with the driver's air bag module.
52B-69