Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 958

<L.H.>
<R.H.>
Protrusion
Pry bar Hammer
MB991721
Output shaft
Front of the vehicle
Transfer assembly
MANUAL TRANSMISSION - Transfer Assembly
AB" DRIVE SHAFT <L.H.>/DRIVE SHAFT <R.H.>
1. As shown in the figure, pull out the transfer shaft <L.H.>
Transmission
side
Pry bar
2. Cover with a cloth to prevent foreign particles from entering
AC" OUTPUT SHAFT REMOVAL
1. Using the special tool (MB991721), remove the output
2. Cover with a cloth to prevent foreign particles from entering
AD"TRANSFER ASSEMBLY REMOVAL
With the engine mount and transmission mount installed,
roll the engine and transmission assembly towards the front
of the vehicle, and remove the transfer assembly from between
the engine block and crossmember.
Engine and
transmission
assembly
DISCONNECTION
from the transmission using the pry bar. As shown in
the illustration, press a hammer, etc. against the driveshaft
<R.H.>, and pull out the driveshaft from the transfer
assembly using the pry shaft.
Caution
As the TJ may damage when the driveshaft is pulled
out from the BJ side, be sure to use the lever.
the transfer.
shaft.
the transmission case.
22A-51