Door Outside Handle Looseness Check; Circuit Breaker Check; Power Window Check - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

BODY -
DOOR OUTSIDE HANDLE LOOSENESS
CHECK
1. Check that the looseness of the door outside handle
satisfies the standard value.
A
Standard value (A):
Front 2.3 ± 2.1 mm
Rear 1.3 ± 1.7 mm
2. Check the door outside handle and door latch assembly.
If faulty, replace.
POWER WINDOW OPERATING CURRENT
CHECK
1. Remove the power window fuse, and connect the circuit
tester as shown in the figure.
2. When the power window switch is set to the UP side,
a large amount of operating current flows when the window
is operated or closed. Therefore measure somewhere
in between excluding these positions.
Standard value: 5 ± 1A (Power supply voltage
14.5 ± 0.5 V, 25_C)
3. If outside the standard value, perform troubleshooting.
(Refer to GROUP 54B.)
CIRCUIT BREAKER CHECK (Incorporated in
the power window motor)
1. Set the power window switch to the UP side until the
window glass closes completely, and continue operating
the switch for more than 10 seconds.
2. Release the power window switch at the UP side, and
at the same time, press the DOWN side. Under this
condition if the window glass starts to lower within 60
seconds, the circuit breaker can be determined as good.

POWER WINDOW CHECK

Check that the power window operates. If it does not, perform
troubleshooting. (Refer to GROUP 54B.)
Doors
42-23