Transfer Assembly - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

TRANSFER ASSEMBLY

REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Under Cover Removal and Installation (Refer to GROUP 51 - Front Bumper.)
D
Side Under Cover Removal and Installation
D
Transmission Oil Draining and Supplying (Refer to P.22A-40.)
D
Transfer Oil Draining and Supplying (Refer to P.22A-40.)
D
Engine Coolant Draining and Supplying (Refer to GROUP 14 - On-vehicle Service.)
D
Crossmember Bar Removal and Installation (Refer to GROUP 32 - Engine Roll Stopper, Centermember.)
D
Front Exhaust Pipe Removal and Installation (Refer to GROUP 15 - Exhaust Pipe and Main Muffler.)
D
Battery and Battery Tray Removal and Installation
D
Air Cleaner, Air Intake Hose Removal and Installation (Refer to GROUP 15 - Air Cleaner.)
D
Secondary Air Hose Removal and Installation (Refer to GROUP 15 - Secondary Air Control System.)
D
Strut Tower Bar Removal and Installation (Refer to GROUP 42.)
D
Air Hose E, Air By-pass Hose and Air By-pass Valve, Air Pipe C, Air Hose D, Air Pipe B, Air Hose A Removal and
D
Installation (Refer to GROUP 15 - Intercooler.)
Radiator Removal and Installation (Refer to GROUP 14.)
D
Bleeding and Hydraulic Pressure Check <ACD> (Refer to P.22A-42, 43) <after installation only>
D
7
Removal steps
1. Stabilizer bar connection
2. Stabilizer link
3. Wheel speed sensor cable clamp
and brake hose clamp
MANUAL TRANSMISSION - Transfer Assembly
8
3
6
108 ± 10 N·m
39 5 N·m
±
1
39 ± 5 N·m
4. Tie rod end connection
AA"
5. Lower arm ball joint connection
6. Drive shaft <L.H.> connection
AB"
7. Drive shaft <R.H.> connection
AB"
8. Output shaft
AC"
22A-49
25 5 N·m
±
245 29 N·m
±
4
2
5