Headlamp Bulb (High Beam)Replacement; Position Lamp Bulb Replacement; Front Turn Signal Lamp Bulb Replacement; Headlamp Auto Cut Adjustment Procedure - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

Headlamp bulb
<High beam>
Position lamp
CHASSIS ELECTRICAL - CHASSIS ELECTRICAL - CHASSIS ELECTRICAL -

HEADLAMP BULB (HIGH BEAM)REPLACEMENT

(1) Disconnect battery.
(2) Disconnect connector.
(3) Screw out socket to pull out bulb.
(4) After bulb is replaced, properly reconnect connector.
Caution
Do not touch bulb surface bare-handed or with dirty
gloves. If dirt is attached on glass surface of the bulb,
immediately use alcohol or thinner to remove dirt, and
install the bulb after well dried.

POSITION LAMP BULB REPLACEMENT

1. Remove the splash shield.
2. Disconnect the connector and remove the socket of the
Caution
Do not touch bulb surface bare-handed or with dirty
gloves. If dirt is attached on glass surface of the bulb,
immediately use alcohol or thinner to remove dirt, and
install the bulb after well dried.
FRONT TURN-SIGNAL LAMP BULB
REPLACEMENT
1. Remove the splash shield.
2. Disconnect the connector and remove the socket of the
Caution
Do not touch bulb surface bare-handed or with dirty
gloves. If dirt is attached on glass surface of the bulb,
immediately use alcohol or thinner to remove dirt, and
install the bulb after well dried.
HEADLAMP AUTO CUT ADJUSTMENT
PROCEDURE
Headlamps are controlled smart wiring system (SWS). For
adjustment procedure of headlamp auto lamp and headlamp
auto cut, refer to GROUP 54B.

HEADLAMP AUTO CUT FUNCTION CHECK

When lighting switch is turned ON (to HEAD position) with
ignition switch removed from ignition key cylinder and driver's
door is opened, ensure that headlamps are switched off after
one second. When headlamps are inoperative, perform
troubleshooting. (Refer to GROUP 54B.)
Headlamp Assembly Headlamp Assembly Headlamp Assembly
position lamp by turning to left.
front turn signal lamp by turning to left.
54A-29