Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 631

51-24
Section A – A
Flat-tipped
screw driver
A
A
Notch
Flat-tipped screw driver
EXTERIOR - EXTERIOR -
REMOVAL SERVICE POINT
Mirror
AA" MIRROR REMOVAL
Tilt the mirror upward, insert the flat-tipped screw driver
wrapped around with the protection tape between the notch
located behind the mirror and pivot plate, and pry off the
mirror.
Pivot plate
INSPECTIONS
REMOTE CONTROLLED MIRROR ASSEMBLY CHECK
<RS - II>
Battery connection terminal
1
THERMAL PRINTED WIRE FUNCTION CHECK
For vehicles with thermal printed wires, check that there is
continuity between terminals (1) and (4).
Outside Mirror Outside Mirror
2 3
Operation of mirror
Up
Down
Right
Left