Pole Antenna - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

POLE ANTENNA

REMOVAL AND INSTALLATION
Removal steps
1. Antenna base
AA"
2. Radio plug
3. Knob assembly
4. Center panel assembly (Refer to
GROUP 52A - Instrument Panel.)
String
Tape
Hole
String
CHASSIS ELECTRICAL -
1
REMOVAL SERVICE POINT
AA" ANTENNA BASE REMOVAL
Use the following steps to easily route antenna feeder cable
in the event of installation:
1. Tie string at the top end of feeder cable.
2. Pull out feeder cable until pipe end of antenna base is visible.
3. Insert string into the hole at pipe end of antenna base,
Junction block
4. Gradually pull out remove antenna base.
Pole Antenna
D Instrument under cover (Refer to
GROUP 52A - Instrument Panel.)
D Instrument panel (Refer to GROUP
52A.)
5. Antenna feeder cable
and wrap vinyl tape on the string.
Caution
Tape should be wrapped so that the string cannot
be removed.
54A-41
2
3
4
5