Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 702

STEERING - Power Steering Gear Box and Linkage
Rack
bushing
Rack
Plastic tape
Rack bushing
Circlip
Slot
MB990925
(MB990938)
MB991203
Upper oil
seal
MB991317
"DA OIL SEAL/RACK BUSHING INSTALLATION
1. Apply specified fluid to the outer surface of the oil seal.
MB990925
Using the special tool, press in the oil seal until it is flush
(MB990927)
with the bushing end face.
Oil seal
Specified fluid:
O-ring
Caution
Do not use ATF-SP II M and ATF-SP III.
2. Apply the specified fluid to the oil seal inner surface and
the O-ring.
Specified fluid:
Caution
Do not use ATF-SP II M and ATF-SP III.
3. Wrap the rack end with plastic tape, and push the rack
bushing onto the rack.
"EA CIRCLIP INSTALLATION
Circlip
Align the mark on the rack stopper and the slot in the cylinder.
Then, insert the circlip into the rack stopper hole through
the cylinder hole. Turn the rack stopper clockwise and insert
the circlip firmly.
Slot
"FA UPPER OIL SEAL/UPPER BEARING
MB990925
(MB990938)
MB991203
Bearing
"GA SEAL RING INSTALLATION
After installation, using the special tool or by hand, compress
seal rings that expand during installation.
Automatic transmission fluid DEXRON II
Automatic transmission fluid DEXRON II
INSTALLATION
37A-25