Starting Disabled (Starter Does Not Rotate) - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

13A-58
Inspection Procedure 5
Starting disabled (Starter does not rotate.)
Causes shown on right are suspected.
Check the battery.
(Refer to GROUP 54 - Battery.)
OK
MUT-II Data list
D No. 18: Cranking signal
D Ignition switch: ST
OK: ON
D Ignition switch: ON
OK: OFF
OK
Check the following connector:
B-19
OK NG
Repair
Measure at the B-19 starter connector.
D Disconnect the connector to
measure at the harness side.
D Ignition switch: ST
D Voltage between terminal No. 1 and
earth
OK: System voltage
OK
Check the following connector:
B-18
OK
Measure at the B-18 starter connector.
D Disconnect the connector to
measure at the harness side.
D Ignition switch: ST
D Voltage between terminal No. 1 and
earth
OK: System voltage
OK
Check the harness between the ignition
switch and starter.
D Check for damage of the output
cable.
NG
Repair
MPI -
Troubleshooting
NG
Replace the battery.
NG
Check the following connector:
C-201
OK
Check the ignition switch.
(Refer to GROUP 54 - Ignition Switch.)
OK
Check the following connectors:
C-129, C-115
OK
Check the harness between the igni-
tion switch and engine-ECU.
D Check for disconnection,
short-circuit and damage of the
output cable.
OK
Check the following connectors:
B-14, B-19
OK
Check and repair the harness between
the ignition switch and starter.
D Check for short-circuit of the output
cable.
NG
Check the following connector:
B-14
OK
Check and repair the harness between
the ignition switch and starter.
D Check for disconnection of the
output cable.
NG
Repair
NG
Check and repair the harness between
the battery and starter.
D Check for disconnection and
short-circuit of the power cable.
OK
Check the harness between the bat-
tery and starter.
D Check for damage of the power
cable.
Replace the starter.
Probable cause
D Battery malfunction
D Ignition switch malfunction
D Starter malfunction
NG
NG
NG
NG
NG
NG
NG
OK
Repair
Replace the ignitionswitch.
Repair
Repair
Repair
Repair
Repair