Water Pump - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

WATER PUMP

Caution
If the vehicle is equipped with the Brembo disc brake, during maintenance, take care not to contact
the parts or tools to the caliper because the paint of caliper will be scratched.
REMOVAL AND INSTALLATION
Pre-remobal and Post-installation Operation
Engine Coolant Draining and Supplying (Refer to P.14-6.)
D
Timing Belt Removal and installation (Refer to GROUP 11A.)
D
Bolt specifications
2
8× 25
8 × 22
Nominal diameter
×
22 ± 4 N·m
Removal steps
1. Alternator brace
2. Water pump
3. Water pump Gasket
"AA 4. O-ring
ENGINE COOLING -
8 × 22
8× 70
8 ×14
Nominal length mm
1
23 ± 3 N·m
14 ± 1 N·m
INSTALLATION SERVICE POINT
Water pump
"AA O-RING INSTALLATION
Fit an O-ring into the O-ring groove located at the end of
O-ring the water inlet pipe and apply water to the O-ring or the
inside of the mounting surface of the water pump for insertion.
CAUTION
Do not let the O-ring get contaminated with grease, such
Water inlet pipe
as engine oil.
Water Pump
4
2
3
14-13