Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 747

35A-28
Lock pin
<Front>
Front of
vehicle
Guide pin
<Rear>
Guide pin
Identification
mark "B"
Identification mark "A"
BASIC BRAKE SYSTEM -
"AA LOCK PIN/GUIDE PIN INSTALLATION
<Except for Brembo disc brake>
Identification
mark "L"
As shown in the illustration, align the identification mark on
the caliper body and the head mark of the guide pin/lock
pin, then install the guide pin/lock pin.
Identification
mark "G"
Rear of
vehicle
Lock pin
INSPECTION
D
D
D
D
PAD WEAR CHECK
Measure thickness at the thinnest and worn area of the pad.
Replace the pad assembly if the pad thickness is less than
the limit value.
Standard value:
Limit: 2.0 mm
Caution
1. Always replace the brake pads as an axle set.
2. If an excessive difference is found in the thickness
Disc Brake
Check the cylinder for wear, damage or rust.
Check the piston surface for wear, damage or rust.
Check the caliper body or sleeve for wear.
Check pad for damage or adhesion of grease, check
the backing metal for damage.
10.0 mm <Front, Rear (Except for Brembo disc brake)>,
9.0 mm <Rear (Brembo disc brake)>
between the right and left brake pads, check moving
parts.