Side Air Dam, Molding And Garnish; Special Tool; Adhesive - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

51-8
EXTERIOR -
Riveter
Bumper face
Bumper side
plate
Bumper face
1
Rivet
2
3
Flange part
4
Rivet

SIDE AIR DAM, MOLDING AND GARNISH

SPECIAL TOOL

Tool

ADHESIVE

Application
Side air dam
Rear Bumper / Side Air Dam, Molding and Garnish
REASSEMBLY SERVICE POINTS
"AA RIVET INSTALLATION
Use the recommended tool shown in the illustration to secure
the rivet in the following procedure.
1. Insert the rivet into the main materials (rear bumper face
and rear bumper side plate.)
2. Insert the recommended tool into Part A of the rivet.
3. Maneuver the handle of the tool pressing the flange of
the rivet.
4. Particles of Part A of the rivet are cut off to be secured.
Part A
Riveter
Number Name
MB990449 Window molding
remover
Brand
Double-sided tape [5 mm width 1.2 mm thickness]
Application
Removal of roof drip molding